1.主持中国博士后科学基金特别资助（国家级），18万元（配套资助18万元）
2.主持广东省基础与应用基础研究基金委员会（省部级青年项目），10万元
3.参与广东省重点领域研发计划（省部级），1600万元
4.Chen Z, Wan B, Liu J, et al. Sintering densification mechanism of binder jet 3D printing 316L stainless steel parts via dimensional compensation technology[J]. Journal of Materials Research and Technology, 2024, 33: 3296-3307.
5.Chen Z, Wang F, Jiang Z, et al. A new phenomenon in a selective laser melted 316L stainless steel with a wider and higher laser energy density[J]. Journal of Materials Research and Technology, 2024, 30: 1735-1750.
6.Chen Z, Jiang Z, Wang F, et al. Deformation behavior of additive manufactured 316 L stainless steel using in situ neutron diffraction[J]. Scientific Reports, 2025, 15(1): 3104.
7.Chen W, Chen Z, Chen L, et al. Optimization of printing parameters to achieve high-density 316L stainless steel manufactured by binder jet 3D printing[J]. Journal of Materials Engineering and Performance, 2023, 32(8): 3602-3616.
8.Chen Z, Chen W, Chen L, et al. Influence of initial relative densities on the sintering behavior and mechanical behavior of 316 L stainless steel fabricated by binder jet 3D printing[J]. Materials Today Communications, 2022, 31: 103369.
9.Chen Z, Li F, Chen W, et al. Numerical simulation of particle size influence on the sintering behavior of 316L stainless steel powders fabricated by binder jet 3D printing[J]. Journal of Materials Engineering and Performance, 2021, 30(5): 3705-3717.
10.陈志平; 粘结剂喷射3D打印和选区激光熔化316L不锈钢的组织和性能研究, 2025第三届全国金属增材制造及注射成形技术与应用交流会, 山西太原, 2025-06-13至2025-06-15 (会议报告)
